TIG Time with Mr. TIG
How to Weld Sheet Metal
Written by Mr. TIG (Wyatt Swaim)
What you will learn in this episode:
This episode was a request directly from one of our users. What we were asked was to show a full penetration weld of sheet metal and explain all the settings/ parameters to demonstrate how we got the results.
TIG Welding Inconel for Beginners
Written by Mr. TIG (Wyatt Swaim)
What you will learn in this episode:
In this episode, we are still at the Indianapolis Motor Speedway doing welding for many of the race teams. Since so many of these cars utilize Inconel for its heat resistance, we thought "what better time to show all you beginners out there how to get started". Read More
How to Weld Aluminum with Controlled Penetration
Written by Mr. TIG (Wyatt Swaim)
What you will learn in this episode:
In this episode of TIG Time, you will learn how to control the penetration when you are welding Aluminum. Generally this can be a difficult task, but we are going to show you how you can get the exact profile that you need with the use of a ceramic backing bar.
TIG Time Welds the Indy 500
Written by Mr. TIG (Wyatt Swaim)
TIG Time has been at the track for the past week and we will be shooting live until race day. Here is a little intro we did during a practice day!
Thanks again to Carpet Baggers for inviting us to the suite to shoot this video.
How to TIG Weld 6061 Aluminum Pipe
Written by Mr. TIG (Wyatt Swaim)
What you will learn in this episode:
In this episode of TIG Time, we took a trip to the Arkansas River where we found some Air-boats in need of welding. The boat's "pancake section" is made of 6061 .120 Aluminum Tubing and the Engine mount is made of 6061 one inch Aluminum pipe. In this episode we talk about proper equipment, fit up, weld technique and more.
